Navigation

Sneak Peek: TOPS Knives Hammer Hawk Prototype Sheath

By on March 16, 2017 in Knives, Survival

TOPS Knives rolled out several new products at SHOT Show and the Hammer Hawk was likely the most talked about. The details of the full-tang tomahawk were mostly ironed out at the time of the show but TOPS did state that they were still working on the sheath for both the tomahawk its companion knife.

Now we have this sneak peek of the prototype sheath set up. Details are likely to change on the production version but this gives us a sold idea of what we can look forward to. It looks like TOPS will have a belt sheath for the companion knife and a bit cover that still allows the user access to the Hammer Hawk’s hammer poll when installed.

TOPS also tells us that the Hammer Hawk is likely not going to make it retail until sometime the last half of 2017 (Q3 or Q4).

TOPSKnives.com

RE Factor Tactical – The Aggressor

By on March 15, 2017 in Tactical Gear

The Aggressor from RE Factor Tactical is a low-profile pack that is designed to be mounted on and fit closely to the rear plate pocket of a plate carrier. It can also be used as a stand-alone backpack.

The included medical sleeve may be carried inside the pack and then quickly accessed via a pull tab out of the bottom of the pack. Once free from the pack, the user can make use of the sleeve’s clam shell opening design to lay it flat and gain full access to the organized medical supplies it is designed to carry (see the video below to see this in action).

The back panel can accept a 1.5L hydration bladder. The pack can also be used without the medical sleeve to carry general items. The Aggressor also features webbing for attaching other items and a large loop field for patches or ID.

  • Made in the USA (Berry Compliant)
  • 9 x 12 x 1″ (expands to 6″ deep)
  • 1000D Cordura
  • 1lb
  • MOLLE mountable
  • Ambidextrous access pull to inner sleeve
  • Fits 1.5L hydration bladder (not included)

Check out the Aggressor at REFactorTactical.com

Sintercore Tripwire for the M&P 15-22

By on March 15, 2017 in Guns

Sintercore’s Tripwire Charging Handle is lightweight, simple, robust, and coming to a Smith & Wesson M&P 15-22 near you. Sintercore introduced the lever-less Tripwire for the AR-15 several years ago and now they are in the process of adapting it to work on the popular rimfire training rifle.

The image below shows aluminum prototypes before their final milling processes were complete. The prototypes have been completed and tested for fit so production pieces may not be too far behind. The production charging handles will weigh less than 1 ounce and feature a Cerakote finish available in a handful of colors.

You can pre-order now at Sintercore.com.

Tennessee Arms Co. to Produce TAC-9 Lowers – Polymer, Glock Mag Compatible, AR-15 Lowers

By on March 14, 2017 in Guns

Tennessee Arms Company is known for their polymer AR-15 and AR308 lowers. They are now moving into a third caliber – 9mm.

The following images show the tooling for their upcoming TAC-9 lower receivers. These polymer lowers will be compatible with Glock magazines, available in all the colors that TN Arms Company is known for, and will share many of the same features as their AR-15 lowers.

The tooling is expected to be complete by the end of the month with production TAC-9 receivers to follow.

Powered by WordPress. Designed by Woo Themes