Forward Controls Design TGF (Trigger Guard, Forward Controls)

The new TGF (Trigger Guard, Foward Designs) is now available from Forward Controls Designs. It shows the same utilitarian design and attention to small details like angles and dimensions that you are used to from FCD.

From Foward Controls Design:

TGF (Trigger Guard, Forward Controls) is available in standard (straight) and winter versions. Both are machined from 7075 aluminum, they do not have spring loaded detent for the front, but use a set screw like Magpul’s, and a standard trigger guard roll pin in the rear. 

Both versions feature a canted front edge to make rocking the magazine into the mag well easier. The winter version has as much constant/unchanged space from the trigger bow forward as possible (instead of of the space inside tapering and decreasing as the trigger guard nears the receiver’s front trigger guard holes). The space to the rear of the trigger bow is inaccessible for the user’s finger, so it’s kept small and low. Available in anodized black, desert tan, and OD green (desert tan and OD green for standard/straight TGF in 2020).

TGF is designed for use with in spec forged lower receivers, and fills the gap forward of the pistol grip, between the trigger guard “ears” (note that TGF will not swing down like TDP spec trigger guards).  All the sharp edges and corners have been removed.    Due to the variations and tolerances of receivers, fitting might be required for receivers too far from TDP dimensions and tolerances.

FowardControlsDesign.com

Comments are closed.

Powered by WordPress. Designed by Woo Themes