Tactical Handyman: Tournequit Retention Doohicky

So you need a way to keep your tourniquet at hand? Well the Tactical Handyman has the simple (and cheap) way to build your own Tourniquet Retention Doohicky or TRD (pronounced turd). If you are anything like the Tactical Handyman, you have the stuff to make one laying around already. Why pay $5-12 plus shipping for something you can make on the cheap?

Image

Necessary Materials:
– Short piece of mil-spec shock cord

Optional Materials:
– Cord End
– Cord Lock

Instructions:
This isn’t rocket science. This is simply a loop of shock cord. The cord ends are nice since shock cord will fray readily but a simple knot will do. You will have to experiment with different lengths in until you find a length small enough to really secure your tourniquet. The cord lock allows you to make your TRD a bit more universal. You can cut it a little bit long and use the cord lock to take up the slack.

Simply thread the TRD behind two rows of webbing like so:
Image

Now you can stretch the ends over your tourniquet. I found that the cord stayed out of the way well if I twisted it so the ends were to the side like so:
Image

Or, you can loop the end onto the windlass or other part of the tourniquet:
Image

I found that spanning 2 rows works best because it allows the cord to be placed toward the center of the tourniquet but still have a couple of inches in between straps for stability. If you get the straps toward the center of the tourniquet and make them tight enough the tourniquet is locked down and isn’t going anywhere. This type of design is common to most tourniquet holders. The ability to loop the small tab onto something like the windlass gives a 3rd contact point and even more confidence that you will not lose your life saving gear. If you felt the need, a third strap could easily be added, but I think it is unnecessary.

To remove the tourniquet quickly, simply pull on the cord end (or knot) which will free the top (or bottom depending how you have it positioned). Once one end is free the tourniquet can be tugged to be released from the remaining loop. This can easily be accomplished with one hand.

This sure beats rubber bands. The Tactical Handyman has your back.

I am using the SOF-T Tourniquet in the pics but this should adapt to just about any model.

PS – This works great on the webbing that is sewn on the side of many blow out kit pouches like the HSGI Bleeder Pouch.

wordpress hit<br /> counter

Add to FacebookAdd to DiggAdd to Del.icio.usAdd to StumbleuponAdd to RedditAdd to BlinklistAdd to TwitterAdd to TechnoratiAdd to Yahoo BuzzAdd to Newsvine

, , ,

Comments are closed.

Powered by WordPress. Designed by Woo Themes